Crestron HD-TX-301-C-E DM Lite Over Catx Tran
Crestron HD-TX-301-C-E DM Lite Over Catx Tran - Image 2
Crestron HD-TX-301-C-E DM Lite Over Catx Tran - Image 3
Crestron HD-TX-301-C-E DM Lite Over Catx Tran - Image 4
,

Crestron HD-TX-301-C-E DM Lite Over Catx Tran

Availability:

181 in stock
Compare

55,660 EGP

181 in stock

Crestron HD-TX-301-C-E DM Lite Over Catx Tran

Compare
Video
Switcher 3×1 manual or auto-switching, audio-follow-video
Input Signal Types HDMI with Deep Color, 3D, and 4K (DVI and Dual-Mode DisplayPortTM interface compatible3), VGA/RGB (RGBHV, RGBS, RGsB), component (YPbPr)4
Copy Protection HDCP 1.4
Maximum Resolutions

Input
Type		 Scan
Type		 Resolution Frame
Rate		 Color
Sampling		 Color
Depth
HDMI Progressive 4096×2160 DCI 4K
&
3840×2160 4K UHD		 24 Hz 4:4:4 30 bit
30 Hz 4:4:4 24 bit
30 Hz 4:2:2 36 bit
60 Hz 4:2:0 24 bit
2560×1600 WQXGA 60 Hz 4:4:4 36 bit
1920×1080 HD 1080p 60 Hz 4:4:4 36 bit
Interlaced 1920×1080 HD 1080i 30 Hz 4:4:4 36 bit
VGA/RGB Progressive 1600×1200 UXGA 60 Hz n/a
1920×1200 WUXGA 60 Hz n/a
Component Progressive 1920×1080 HD 1080p 60 Hz n/a
Interlaced 1920×1080 HD 1080i 30 Hz n/a
NOTE: Common resolutions are shown; other custom resolutions are supported at pixel clock rates up to 300 MHz for HDMI or 165 MHz for VGA.
Audio
Input Signal Types HDMI (Dual-Mode DisplayPort interface compatible3), analog stereo
Digital Formats Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS®, DTS ES, DTS 96/24, DTS HD High Res, DTS-HD Master Audio, DTS:X, LPCM up to 8 channels
Analog Formats Stereo 2-channel
Analog-To-Digital Conversion 24-bit 48 kHz
Analog Performance Frequency Response: 20 Hz to 20 kHz ±0.5 dB;
S/N Ratio: >93 dB, 20 Hz to 20 kHz A-weighted;
THD+N: <0.005% @ 1 kHz;
Stereo Separation: >80 dB
Communications
HDMI HDCP 1.4, EDID, CEC pass-through
USB USB host for one TT-100 series cable caddy
DM Lite Link Proprietary link for connection between one DM Lite transmitter and and DM Lite or DMPS Lite receiver only
NOTE: Supports management of HDCP and EDID only when paired with an HD-RX-201-C-E or DMPS Lite receiver; supports management of CEC between the connected HDMI devices and a control system only when paired with an HD-RX-201-C-E or DMPS Lite receiver.
Connectors
HDMI 1 – 2 INPUT (2) HDMI Type A connectors, female;
HDMI digital video/audio inputs (DVI and Dual-Mode DisplayPort interface compatible3)
VGA 3 INPUT (1) HD15 connector, female;
RGB (VGA) or component video input4;
Formats: RGBHV, RGBS, RGsB, and YPbPr
AUDIO INPUT (1) 3.5 mm TRS mini phone jack;
Unbalanced stereo line-level audio input;
Maximum Input Level: 2 Vrms;
Input Impedance: 44k Ohms
TO RX (DM Lite) (1) 8-pin RJ-45 connector, female, shielded;
DM Lite link port for connection to a DM Lite or DMPS Lite receiver1
24VDC 1.25A (1) 2.1 x 5.5 mm DC power connector;
24 VDC power input;
PW-2412WU power pack included;
NOTE: This connection powers both the transmitter and receiver.2
SERVICE (1) USB Type A connector, female;
USB host port for one TT-100 series cable caddy
Controls and Indicators
TO RX (DM Lite) (2) LEDs on RJ-45 connector, green LED indicates DM Lite link status, amber LED indicates a valid video signal
PWR (1) Bi-color green/amber LED, indicates operating power is supplied from the receiver via the DM Lite link or from a power pack via the 24 VDC input, turns amber while booting and green when operating
AUTO (1) Pushbutton to enable/disable auto-switching mode, and (1) green LED to indicate auto-switching mode is enabled
INPUT 1 – 3 (3) Pushbuttons for manual input selection, and (3) bi-color green/amber LEDs to indicate the current active input and signal presence at each corresponding input
SETUP (1) Red LED and (1) recessed pushbutton for Ethernet setup (only when paired with an HD-RX-201-C-E or DMPS Lite receiver)
Power
Power Pack (included) Input: 100-240 Volts AC, 50/60 Hz;
Output: 1.25 Amps @ 24 Volts DC;
Model: PW-2412WU
NOTE: The transmitter and receiver are powered together using a single power pack connected at either the transmitter or receiver.2
Environmental
Temperature 32° to 104° F (0° to 40° C)
Humidity 20% to 90% RH (non-condensing)
Heat Dissipation 19.4 BTU/hr
Construction
Chassis Metal, black finish, with (2) integral mounting flanges, vented sides
Mounting Freestanding, surface-mountable, or attach to a single rack rail
Dimensions
Height 1.11 in (28 mm)
Width 7.70 in (196 mm)
Depth 5.12 in (130 mm)
Weight
20.0 oz (567 g)
Compliance
UL® Listed for US and Canada, CE, IC, FCC Part 15 Class B digital device
Regulatory Model HD-TX-301-C-E
Maximum DM Lite Link Cable Lengths

Resolution

 Cable Type
CAT5e (or higher),
DM-CBL-ULTRA DM® Ultra Cable, or
DM-CBL-8G DM 8G DM 8G® Cable1
1920×1080 FHD 1080p 230 ft (70 m)
1920×1200 WUXGA
1600×1200 UXGA
2048×1080 DCI 2K
2048×1152 QWXGA
2560×1080 UWFHD 130 ft (40 m)
2560×1440 WQHD
2560×1600 WQXGA
3840×2160 4K UHD
4096×2160 DCI 4K
SKU: #0094 Categories: , Tag:

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “Crestron HD-TX-301-C-E DM Lite Over Catx Tran”

There are no reviews yet.

Related products

SHOPPING CART

close